Due to its extremely strong construction, FaBLINE has outstanding resistance to temperature and pressure, much higher than that of conventional convoluted PTFE lined hose.
All sizes and grades of FaBLINE hose are usable at vacuum to -0.9bar up to 200 ˚C. Above this, the vacuum resistance should be reduced 2% for every degree above 200 ˚C.
In practice, flow rates will vary with hose flexing, fluid viscosity, end fitting design and other parameters, but FaBLINE hose flow rates are always around 2 times better than convoluted PTFE hose, when comparing hose assemblies with PTFE lined (non bore-restricted) end fittings.
If it is required to determine the flow rate of a particular hose assembly, or if it is required to determine the pressure required to generate a certain flow rate, then this can sometimes be approximately calculated by the FaBLINE supplier.
It should be noted that calculations can only be made for fluids with a viscosity equal to water, and for hose assemblies with PTFE lined end fittings (no bore restrictions at the ends of the hose).
The following information should be given to the supplier
To calculate the Flow Rate in Cubic Metres per Hour:
OR To Calculate the Pressure Drop in bars over the length of the Hose Assembly: