PTFE Hose - Use with Halogens  -  When PTFE lined hose is used with the halogens Chlorine and Fluorine or any corrosive halogen compounds which diffuse easily and are gaseous for example phosgene, then trace quantities may diffuse through the PTFE liner to the outside.

Only trace quantities are required, mixed with atmospheric moisture to create a serious condition with stainless steel wire braid in particular.  Also if any Halogen compounds are present in the environment external to the hose (for example, salt in a sea water spray) and if the temperature of the hose exceeds 50ºC there is a serious risk of "Chloride Stress Corrosion" of the stainless steel wire braid on the hose.  For such applications, always use the alterative braid materials, either HB or KYB (for fluorine & chloride) or PB (for external chlorides).

“Penetrating” Fluids and Gases - Like other plastics and rubbers, in certain special circumstances PTFE is sometimes subject to diffusion through the tube wall, dependant upon the nature of the chemical, and the pressure and temperature of operation.

As mentioned above, Halogens represent a specific problem. Automotive fuels, on the other hand, diffuse much less through PTFE than through other plastics, like nylon.

Some other types of penetrating fluids can also diffuse through PTFE to varying degrees, which may or may not present a problem. Known examples are sulphur trioxide, glacial acetic acid and methyl methacrylate.

Consult with Aflex Hose if these, or any other gases or fluids which are known to be penetrating are to be used.

Gas/Fluid Cycling  -  There are some application where the fluid passing through the hose turns into a gas, then back into a fluid, then back into a fluid, then into a gas etc., in a cyclic sequence. 

This is normally associated with changes in temperature and/or pressure.  For complex reasons these conditions are extremely damaging to the hose liner, whatever material it is made from.

For example, hoses are sometimes used to pass steam, water, steam etc into rubber moulding presses, in order to heat the mould, then rapidly cool it before reheating in the next cycle.  Hoses of all types fail rapidly in such an application and PTFE lined hoses are no exception. 

Please contact Aflex Hose for further information if these conditions apply.

Connecting Assemblies for Use in Applications  - When being connected for use in applications, the end fittings on hose assemblies must be connected to correct mating parts in the correct way, using the correct tools, spanners, clamps, nuts and bolts etc.  The connections must be sufficiently tightened to ensure that the joint is leak free but not be over tightened as this can damage the connection.

In applications involving the transfer through the hose of expensive or dangerous fluids or gases, the connections must be pressure tested first before being put into service.  This should be done with some harmless media, like water or compressed air, to 1½ times the maximum working pressure of the hose assembly, as stated above.

If in doubt please contact Aflex Hose for advice.